3 Axis TB6560 Stepper Driver Board + Manual Handle Remote Control

Features:

• Toshiba TB6560AHQ chip - maximum 3.5A drive current, more powerful !
• 1 - 1/16 microstep setting - higher accuracy, smoother operation !
• Overload & over-current & over-temperature protection, full protection of your computer and peripheral equipment
• 4 files current settings can be set according to the user the actual current requirement
• Full closed-type optical isolation to protect the user's computer and equipment
• Professional design, two-stage signal processing, super anti-jamming
• Bipolar constant current chopper drive motor low-speed non-creeping phenomenon, noise, non-resonant region
• Four input control, you can set limit, emergency stop, which is divided into pairs of knives

Attention:

• Please connect the power supply to the power switch of 12-36 V, 8A
• The power output of 12V shall be applied to the radiator fan of 12V
• The interface of driver shall be connected with 2/4 phase, 4/6/8 leads stepper motor within 3A current
• This board can work with both unipolar and bipolar stepper motors
• The spindle motor is controlled by Parallel Interface. The voltage of the spindle motor must comply with the scope of the supply voltage.

3 Axis Stepper driver Specifications:

Electrical properties (ambient temperature Tj = 25 pm)
Input Power	12 - 36V DC power supply
Stepper motor drive current	3A (peak value 3.5A)/axis
Drive type	Double-pole constant flow PWM actuation output
Compatible Stepper motors	2/4 Phase, 4/6/8 leads stepper motors within 3.5A

Handle Instructions:
 
1: The first drive with a corresponding docking connector board good driver board
2: turn on the power switch, power indicator light
3: Click the corresponding axis manual control buttons, the corresponding stepper motor shaft rotation axis while the corresponding indicator light, release the button to stop stepping motor
4: Manually adjust the speed dial number is about 300 degrees rotation within the (limited spaces on both sides of the fixed position), clockwise rotation acceleration, deceleration counterclockwise rotation.
 
Package included:

• 1 x 3Axis TB6560 Stepper Motor Driver
• 1 x Handle For 3 Axis
• 5 x Wire connectors
• 1 x Cable For Stepper driver
• 1 x Cable For Handle
• 1 x CD software(English Manual & Mach 3)